0-10v Dimming Light Switch IP20 20mA motion sensor module

Ambient learn

Press “Ambient learn” button, the latest surrounding lux value overwrites previous lux value learned, and set as the

daylight threshold. This feature enables the fixture to function well in any real application circumstance.


Test 3s

When“twilight level”set at 0%, it becomes ON/OFF control.
“Test mode”is for testing purpose only, for users to check the functionality and choose the desired
detection range. The sensor goes to test mode automatically after pressing this button.
Test mode defaulted settings--
Daylight sensor=disable
Hold time=3s
Twilight time=N/A
Twilight level=N/A

Users can quit this mode by pressing “ON/OFF”, “Reset”, or any button of “Hold time”. The sensor
settings are changed accordingly .

In this mode, after motion detected, sensor enters into a cycle of 3s on and 2s off (0.5s soft off + 1.5s off).

Permanent ON/OFF function

Press “ON/OFF” button, fixture goes to permanent on or permanent off mode, sensor is disabled.
Settings(Remote control IR12)

press “Auto”, “Reset” or “Ambient learn” to quit this mode.

Dim +/-
After desired brightness is locked down, if user wants to dim again reversely, just press the “Dim” button again and then lockndown the new brightness again.

Sensor mode
Press “Auto” button, the sensor starts to work and all settings remain the same as the latest status before the light was switched on/off.

Reset function
Press “Reset” button, all settings go back to factory default settings.
Factory default settings--
Sensitivity=100%
Daylight sensor=disable
Hold time=90s
Twilight time=5min
Twilight level=10%